POLYURETHANE FOAM DISPENSING GUN – SMART
Apply with a professional spray. The PU foam can accurately control the injection volume. This is cost savings and a reduction in subsequent repairs. I would also recommend visiting automobileremedy.com/tools-and-gadgets/best-grease-guns for more mechanical tools.
The package also includes a small injection beak to help apply the PU foam into the tiny gap.
This is the best tool for professional construction.
SPECIAL FEATURES
HOW TO USE
The package also includes a small injection beak to help apply the PU foam into the tiny gap.
This is the best tool for professional construction.
SPECIAL FEATURES
- The surface of the gun body is shiny electroplated.
- Its humanized design on the adjustment screw allows you to adjust the foam flow with one hand while working.
- The adapter will not jam if foam is supplied at maximum pressure and there is no foam backspray.
- It has nine patents, an exclusive product, highly competitive.
HOW TO USE
- Before using:
- Wear protective gloves.
- Shake the bottle for about 30 seconds, then screw into the injection hole. (DO NOT screw too hard)
- Rotate the ball adjuster, then pull the trigger to fully inject the chemical mixture into the gun.
- The amount of flow can be adjusted using the control.
- After use:
- Removing a jar.
- Scraping hardened foam off the nozzle.
- Turn the bead adjuster to allow any remaining chemicals to drain.
- Clean immediately with a polyurethane foam cleaner.
- Switching precautions can:
- You can switch to a new one only when you have completely completed the last one.
- Remove the empty can and do not point the valve at people.
- Wipe the contact surface with a thin cloth and remove any remaining foam.
- Screw in a new can in less than 1 minute. (Shake the can before screwing in)
- Pull the trigger to inject the foam.
- Warning: Do not point gun and valve at others when switching.
- Between each use:
- One can of PU foam can stay in the dispenser gun for 7 days.
- Bead tightening control.
- Or unscrew the can and clean it with a special cleaning agent before storing.
- If the foam can is not finished yet, you should immediately clean the outlet with a special cleaner.
- If the jar is empty when you're done, clean it with a clear specialty cleaner before storing.
Steps for cleaning the dispenser gun:
Only clean the dispenser gun if it cannot spray evenly or foam flows slowly.
Step 1: Loosen the roller lock.
Step 2: Remove the empty can and do not point the valve at people.
Step 3: Tighten the roller adjuster and screw in the special cleaning agent, then pull the trigger until the cleaning agent starts to spray.
Step 4: Leave the cleaning agent inside for 15 minutes.
Step 5: Repeatedly pulling the trigger until a clear liquid is sprayed.
Step 6: Remove the cleaner and wipe the valve with a cloth.
Step 7: Wipe the barrel of the gun to make sure it is clean.